Lancer Register Forum banner

Reaction score
24

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews About

  • · Registered
    Joined
    ·
    0 Posts
    Hi, I'm looking for a left hand drive steering rack for the evo 4,5 or 6.

    Please email me at dondi@pldtdsl.net

    Thanks,
    Dondi Ayuyao

    · Registered
    Joined
    ·
    41 Posts
    Hi,

    Dou you have a set of bilstien suspension from evo 7/8/9???? with lowering springs if poss. you can contact me on 07921152745 need a quick answer on this.

    · Registered
    Joined
    ·
    8 Posts
    Hi John, i have an evo 5 and the crankshaft pulley has just collapsed on it. just the usual rubber perishing on it with the car sitting for so long. I was wondering if you have any available.
    Thanks Shaun

    · Registered
    Joined
    ·
    7 Posts
    Hello John,

    Late last year I purchased from you mapped ACD ECU, but the installation
    came just this week. Unfortunately, once the problem occurred - ECU does not
    work. When you turn the ignition everything is ok, only one lamp is lit. We
    can also switch between all three modes. Driving about 100 - 200 meters, the
    three lights came on. Turning off the ignition and the ignition turned on -
    again, everything is ok, only one lamp is lit. Driving about 100 - 200
    meters, the three lights came on again.
    Read error with the MUT - error 65. "ABS monitor system open or short
    circuit"
    Installing back the original ECU - everything is working.
    My car is a EVO 8 GSR, 2004/11, LHD European version with AYC.
    Chassis no.: JMBSNCT9A5U000475. Original ACD ECU no.: MN132035
    What could be the problem? How can we tackle this problem?

    With best regards

    Juris Jevhuta.

    · Registered
    Joined
    ·
    5,513 Posts
    hi john iv seen a few posts about evo 8 breakers on here and you keep popping up, im after a E8/E9 front bumper in any colour and thought id give you a shout? have you got any? and how much? can you get it deliverd too?
    thanks pal

    · Registered
    Joined
    ·
    791 Posts
    Hi John,

    Just wanted to confirm you got my email and if you have any other questions give me a shout..

    Cheers Rob

    · Registered
    Joined
    ·
    344 Posts
    Hi,

    I am in need of a part for my rear view mirror...

    It is the part that sits on the top of the mirror, the 'slide' part with the spring in, its the bit that slides into the housing that's attached to the windscreen.

    P.S I need a few more bits to..I have sent you a few mails, PM's etc but I never get a reply?

    · Registered
    Joined
    ·
    367 Posts
    Last Activity: Today 17:40

    Why don't you reply on my PM's?

    I am waiting for the relays for far too long now and you just don't respond to any of my PM's anymore. Whats the deal with that!?

    · Registered
    Joined
    ·
    268 Posts
    Hello john im after a set of coilpacks for a E6, have you got any or know the best place to get them,
    Cheers Dan

    · Registered
    Joined
    ·
    57 Posts
    Hi I was just wondering I am going to look at a White Evo 6 from sva imports in January, I put a post up asking if any1 new anything about them and about there cars and a member on here said you could possibly help in anyway by looking at the car with me or me bringing the car to you if he let's me. Any help would be much appreciated as I don't know much about evos and I have to take a 360 mile trip to get there.

    Thanks

    Jordan

    · Registered
    Joined
    ·
    2,919 Posts
    Hi john ,havnt forgot I owe you a tenner for roof rail,will see if vik can ring tomorrow and sort it out,thanks very much again Stephen

    · Premium Member
    Joined
    ·
    3,215 Posts
    Hi jon hows it going?
    Im in need of a few bits for my e8 260gsr if you can help?
    I need a
    heater matrix,
    Dash board,
    And one wheel nut thread for the front passenger hub(not sure if theyre all the same but i cross threaded one of mine at teeside)
    oh and a set of carbon window vents if you have them?
    let me you know if you can help cheets-jamie

    · Registered
    Joined
    ·
    59 Posts
    Hi John,
    My name is Archie. I live is USA and I have a EVO V. My wheel bearing/hub on the fronts are both bad and needs replacement. Mitsubishi here doesn't offer EVO V parts since we didn't start getting our EVO until EVO 8. Will the wheel bearing/hub from a EVO 8 fit on my EVO 5? Thanks in advance for you help.

    · Registered
    Joined
    ·
    207 Posts
    Hi John,

    I'm looking for a 1982+ Lancer shell, with 4 doors, bonnet and boot-lid in good condition.
    All other bits are not required.

    It doesn't have to be an "A 173" Turbo Lancer... an ordinary "A 172" 1400cc Lancer will be ideal.

    Please supply quotation if available or if you can, please source a shell from Japan.
    Current MOT is not necessary as the shell will be used to repair a Project that I'm working on at the moment.
    However a valid Commercial Invoice will be needed by local Cutoms to import same.

    Please "pm" or send email to - nix@tstt.net.tt

    Thanks.

    Wade Mitchell.
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top